Replicating Factory Spot Weld Appearance

#15

12-20-2007, 04:05 AM

m22mike

Senior Member

Join Date: Jan 2006

Location: West of CAK

Posts: 5,001

Thanks: 766

Thanked 841 Times in 407 Posts

Re: Replicating Factory Spot Weld Appearance

68bird400HO
Here are a couple of shots of the wheel well lips I did with the tool pictured in the previous post.

Today I made another tool that I like even better, the fe male bushing i used has a tighter ID and the male part of the tool is the end cut off a car door hinge pin.
I also put a nut into the bushing to control the squish out on the back side. Check it out.

Hope this helps, have fun.
Mike

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT. The time now is 06:05 AM.

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.