Neat Machining Video - The Supercar Registry

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.

Join us now! Register now to join The Supercar Registry community!

Yenko.net

		The Supercar Registry > General Discussion > Lounge
Neat Machining Video

Thread Tools

Display Modes

10-12-2007, 04:58 AM

nuch_ss396 nuch_ss396 is offline

Senior Member

Join Date: Oct 2004

Location: Western North Carolina

Posts: 1,713

Thanks: 0

Thanked 0 Times in 0 Posts

Re: Neat Machining Video

Yes Ken, the coating(s) you are referring to are actually
only a few microns thick. Normally, these coatings embed
partially into the substrate of the tool steel ( carbide ).
The faster you run them, the better they cut.
Sounds contradictory, but it's true.

Steve

__________________

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT. The time now is 12:24 AM.

O Garage vBulletin Plugins by Drive Thru Online, Inc.