Powershifting 101

[YENKO DEUCE REGISTRY]

[ QUOTE ]
.... How about all the other gear heads out there. Do any of you really shift without lifting???????????
.....

[/ QUOTE ]

Never!!

[Dog427435]

All the time - have faith!!
-
-

[VintageMusclecar]

Done it more times than I can count!

(although I would tend to be a little more cautious now that the cost of replacement parts has gone through the roof...can't exactly find those replacement Muncies for $300.00 anymore like we used to )

Eric

[3macs1]

One of the best power shifers I have ever driven with is my wife. She has no appreciation for the replacements of parts and like she says you told me 25 years ago put the pedal to the floor and don't let up. I cannot change now just because parts are more expensive.

[PeteLeathersac]

For even more excitement, ever try the modern era vehicle trick of the floored go pedal and clutchless shifting when the rev limiter cuts in...kind've an old Ronnie Sox type trick w/ a new twist!.
First make sure the vehicle actually has a rev limiter then try shifting at higher revs smoothly without the clutch a few times as some vehicles don't like that anyway...but if all seems Ok, bite your lip, hold the gas flat and get ready to bang 'er when the cut out happens...and shift hard and positive too or you may miss it!.
Don't show the kids this one (or Mac's wife?) and it's best saved for beaters or rental cars as it's no doubt risky...but saves on clutch wear?.

~ Pete

[TXZS]

Pete, synchros are more expensive than clutches and a bigger pain to replace. Kinda like the best place for your swimming pool is in your neighbor's yard, this is best practiced on your neighbor's car!

[Salvatore]

Did it forever in the old days. NEVER let your right foot up! Problem is now if you have any older parts they are already metal fatigued so it is not worth the excitement.

[x Baldwin Motion]

[ QUOTE ]

-
-

[/ QUOTE ]

the ultra rare, one of one "post" camaro

[GRB]

The devil would have to be chasing me!