Question about day 2 engine mods

[427TJ]

[ QUOTE ]
Since the carb sits at such an angle to
the engine, I would suspect that the Camaro throttle rod
would not work properly.

[/ QUOTE ]

Nope, we just bent the rod a little and it worked like a charm. The Torker, if memory serves, was a late-70s intake and not really a "Day 2" intake. "Day 2" for a '60s musclecar would have to be something available the day after the car was sold new, maybe within a year or two later. Dual-plane intakes are probably most correct for proper '60s Day 2 modifications, in my opinion. The Torker strikes me more as a '70s "street machine" intake rather than a '60s Day 2 piece. But hey, run what you want to and have fun with it.

[JoeG]

The Tarantula was an earlier manifold that Motion used----

[nuch_ss396]

[ QUOTE ]
The Tarantula was an earlier manifold that Motion used----

[/ QUOTE ]

Joe,

Does the Tarantula have straight runners and the canted
carb mounting configuration I mentioned? Perhaps I got
the intake name wrong.

Steve

[JoeG]

Yes it did, on both counts----I got one from Motion when they first came out---early 70's.........

[427TJ]

Yes! The Tarantula came before the Torker. Thanks for reminding me about that intake Joe, I'm not as old as you! (JOKE!) Wish I'd been there when you were though.

The Tarantula on the Motion Corvette would be correct Day 2--within a few years of the Corvette selling new--thanks to Joe's reminding me that it existed way back.

[JoeG]

[ QUOTE ]
Yes! The Tarantula came before the Torker. Thanks for reminding me about that intake Joe, I'm not as old as you! (JOKE!) Wish I'd been there when you were though.



[/ QUOTE ]

You're welcome sonny...........

[Musclecarkid]

Tarantula intake for Big Block Chevy came out around Feb 71 according to a few magazine ads I've seen. Racers may have gotten then earlier. Edelbrock has a tech line and an email address you can contact with any questions you may have on this subject.

[nuch_ss396]

Well Bill!

That explains why I once found a 2-piece SHP big
block rod that looked like it got into a fight.

Oddly, I saw a B-M Vette at the Forge Show a couple
of years ago and I swear it had the Torker intake on
it and the owner claimed it was a B-M day 2 mod.

Thanks,
Steve