LS6 Chevelle inner fenders

[ORIGLS6]

[ QUOTE ]
My March of 1970 Arlington Texas built LS-6 car has plastic inner fenders.

[/ QUOTE ]

As did my 05D Arlington car. Still have them stuffed overhead in the garage. I guess that's something else I should rectify.

[SS427]

I don't recall you mentioning these were replaced. What happened?

Were you out of commission yesterday? Did you get my e-mails?
Rick

[ORIGLS6]

A couple of splits, like most of them. I probably should put them back since they're really not that bad. Then I'll need to resurrect one of the EB-9As to cover the holes on the driver's side.

VERY busy yesterday...... my apologies. Might make the visit this afternoon though. I'll call first.

[SS427]

[ QUOTE ]
Might make the visit this afternoon though. I'll call first.

[/ QUOTE ]

You're learnin'.

The vet may have to make yet another visit today, and the boiler man has already been there this morning.
Rick

[Bill Pritchard]

[ QUOTE ]
Then I'll need to resurrect one of the EB-9As to cover the holes on the driver's side.

[/ QUOTE ]

Ah, yes, the stuff we used to do.....never thinking of the downside of having non-OEM holes in OEM plastic inner fenders 35+ years later Every respectable performance car had to have a tach back then

[ORIGLS6]

I think I had an RC85 on it first, then switched to an SST90.

I still have all of the original ones (tachs) and have picked up a few more over the years.

So Bill, which set-up should I put back on it?

[Mr70]

This is so tachless, but I'd Leave it the way Chevrolet built it.

The fiber fender skirts were actually made first for the new 1970 Monte Carlos,because it had the longest/heaviest hood (6' feet),among all the other cars in it's fleet at that time.They were also designed to help with road rock noise and help buffer the engine compartment too on the elegant luxurious M/C.
Chevrolet liked this idea,and continued with it on other cars.
Before this,they offered a Steel skirt coated with an added optional sound deadner,which went by part #3975419-20,that was supposed to do the same thing,but wasn't well received.
Arlington Tx. was a New A-body plant beginning in January 1970,so for some reason they were shipped more of these fiber fender skirts then anyother plant for 1970 production it seems to me.
I think that plants used up what they had already,so some vehicles received a fiber on one side,and a metal on the other,if supply deemed it.
Other plants got them later on,but it seems R cars got the lions share for 1970 vehicles built.
By the 1971-72 & up years,these fiber skirts became standard material on all cars at all plants.

[ORIGLS6]

Maybe I'll run with no inner fenders at all! Yank the front bumper off, jack up the front-end, slap a TunnelRam on it, a tach on the dash and go for the Gasser look!

[mockingbird812]

oops.

[mrrec]

Rick, I assume you use the term "fiber" because that is in some Chev literature you have (I'm sure Chev thought fiber sounded better than plastic). The plastic inner fenders are ABS injection molded plastic (at least the ones marked "made in Canada" on my Baltimore LS6). They do have a fiberous quality to them that is evident upon cutting. This was likely a very short strand material that was mixed with the ABS.

My LH had the requisite trouble light hole (you know, lay the trouble light on the inner fender - oops, they're plastic and I've melted a hole in 'em!). I spent many hours cutting a patch out of another part and plastic welding it in with ABS rod - looked pretty good for a year or so, now it's cracked. Darn.

Dave