Using rectangular port intakes on oval port heads

07-16-2006, 06:41 PM

Stefano Stefano is offline

SCR Sponsor

Join Date: Oct 2001

Location: Land of Lincoln

Posts: 9,039

Thanks: 5

Thanked 1,074 Times in 409 Posts

Re: Using rectangular port intakes on oval port heads

I have seen it done many times, over the years. The engine will run without trouble. I don't know all that stuff Eric was taking about, but can tell you that, IMO there is no way the Square to Oval configuration will run as good or better than the Stock Square to Square or Oval to Oval configuration.

__________________
Click to visit the Nickey Performance Facebook-->

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT. The time now is 03:30 PM.

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.