Dick Harrell stripe kit????

1970 1/2 RS/SS Camaro · #1 03-01-2006, 01:19 AM

Kim, don't have a Harrell/Gibb car? (with the stripe on the side) If so, do you know the dimentions on it?
P.S. You have a bad a$$ car...

Kim_Howie · #2 03-01-2006, 01:58 AM

Mark, Starting at the rear of the car they start 2" from the q panel and tailpan seam They are 4.5" wide . The middle of q panel it's 6.5' wide. At the door and q panel lip it's 6" The back of the door it's 6' wide, the middle of the door is 3/4" and front of door is 5/8' The front fender at the back of it it's 5/8 and narrows to a 1/8 round end. The stripe on the front fender is 22" long. hope this helps

1970 1/2 RS/SS Camaro · #3 03-01-2006, 02:10 AM

Cool, thanks

1970 1/2 RS/SS Camaro · #4 03-01-2006, 02:26 AM

Kim do you buy chance have any close up picture(s) of the stripe?
And I'm just wondered do you have a grump lump on your hood?
I just got my 'glass front end and a grump lump hood, but I'm not sure where I'm going to put the scoop hole at. I've seen them on the bottom most of the time but I've also seen them at the top. Does it make a differance?

Kim_Howie · #5 03-01-2006, 06:01 PM

Mark send me your E-Mail

1970 1/2 RS/SS Camaro · #6 03-02-2006, 12:02 AM

Done...

Kim_Howie · #7 03-02-2006, 08:05 PM

Just sent you a E-mail it came back. I used the last on you sent??

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.