mallory unilite problems !!!

[indyjps]

i had to add a ballast inline from power source to keep power surges from frying mine, never had trouble after that. got the info from mallory tech support a couple of years ago.

[musclcar]

that's what i'm using a mallory ballst resistor also all my grounds are either in 4 guage or 8 gauge.my battery is in the trunk so i'm grounded from the [-] side of the bat. to the r/rear frame then from the neg. side of the battery to the trunk bulkhead and both of those are #4 gauge wire. now the engine compartment i'm using an #8 gauge wire from the firewall to a bell housing bolt. all my grounds from the unilite and power scrubber go to the stock alternator bracket.now from there i'm again running a #4 gauge wire from there to the r/front frame rail.the ground picks up from there and then goes to the core support then finally to a fender bolt were the stock ground wire is located at.