Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|
|
#1
|
|||
|
|||
|
Kim, Camaro white Book says VO-1 was Heavy Duty Radiator. Please educate us with what you know of this VO-1 option and if same as came with Big Blocks and ONE piece shroud (VERY Rare ending with #920)
__________________
Chuck Sharin [email protected] Auburn,WA (30 miles South of Seattle) 70 Camaro R/S Z-28, L-78, R/S SS 69 Camaro COPO "recreation" |
|
#2
|
|||
|
|||
|
RPO VO1 is the same radiator used on Z/28 and V8 cars ordered with A/C. VO1 was included when Z/28 ordered.
Kim, your top radiator support panel that holds the shroud should be extended to the drivers side . Same as Z/28. So your should would be the same as the Z/28. I have both base and Z/28 shrouds and panels if you want me to post them. Rick H |
|
#3
|
|||
|
|||
|
Chuck,Enclosed pics from factory man.
__________________
Jake is my grandson!! |
|
#4
|
|||
|
|||
|
2nd pic
__________________
Jake is my grandson!! |
|
#5
|
|||
|
|||
|
3rd pic
__________________
Jake is my grandson!! |
|
#6
|
|||
|
|||
|
Notice the difference in my 6 cyl. plate and a small block plate.
__________________
Jake is my grandson!! |
|
#7
|
|||
|
|||
|
Enclosed is org picture of my car taken 1970 Notice the plate and shroud.I think they are different than the v8 plate and shrould. I have the org. plate on my car and the part # stamped in it is the same as the VO1 # 3973904 This what I am looking for. Kim P.S. my car was a 6cyl. to start with.
__________________
Jake is my grandson!! |
|
#8
|
|||
|
|||
|
Same plate 35 years later!!!
__________________
Jake is my grandson!! |
|
#9
|
|||
|
|||
|
Kim,
The 6 cylinder and non-AC cars had the smaller top panel and shroud as shown in your picture. The Z/28, V8 cars with A/C and special order VO1 option had the 3973904 top panel and 912 and 910 two piece shroud. Also look on your top plate next to the part number. Is there a letter before the number? My 3973904 panel off my Z has an "L" before the number. If I get a chance tomorrow I will get pictures of both the standard panel and shroud and the VO1 option panel and shroud. Kim after looking at your picture you need the 2 piece 912 and 910 shroud. If you are not looking for original you can get the 2 shroud pieces through GM. Approx $45.00 each piece. Rick H. |
|
#10
|
|||
|
|||
|
Kim,
My top panel off my Z is part number 3973904. I am looking at it while I type this. The shroud that fits it is the two piece shroud with part numbers 3973912 and 3973910. As I mentioned it is the same as Z/28 which came with VO1 when ordered. I don't have an extra one. Rick H. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|