69 Camaro Driveshaft Marking??

DarrenX33 · #1 12-20-2005, 08:12 PM

What took you so long Nelson?

Great info.

**SS427** · #2 12-20-2005, 08:34 PM

[ QUOTE ]
What took you so long Nelson?

[/ QUOTE ]

Hey! You're the one with the Camaro and that was the specific question. I figured since you were stumped I would chime in.............

DarrenX33 · #3 12-20-2005, 08:38 PM

[ QUOTE ]
I figured since you were stumped I would chime in.............

[/ QUOTE ]

Your right...

**Kurt S** · #4 12-21-2005, 12:54 AM

There were three driveshafts in 69 Camaros:
manual (SB&BB) & PG
TH350
TH400

That's it.

nuch_ss396 · #5 12-21-2005, 01:31 AM

[ QUOTE ]
There were three driveshafts in 69 Camaros:
manual (SB&BB) & PG
TH350
TH400

That's it.

[/ QUOTE ]

OK Kurt. So what are the three stripe combinations?
Steve

**Kurt S** · #6 12-21-2005, 09:25 AM

I have some of them noted, but haven't tried to reconcile the data. Some stripes rust off first, so the data isn't always consistent... Low on my project list.

Unreal · #7 12-21-2005, 12:29 PM

What's the difference between a TH350 and a manual tranny drive shaft?

My car was originally a TH350, and I converted to an M21, but used the original driveshaft. I haven't had any mechanical problems, but is one brewing?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.