1969 Z-28 041 heads

[budnate]

Honestly dont know guys, the book said application so I went off that, and as far as I can tell these are stock looking heads with screw in studs and big stock looking valves, spring pockets are stock "not" "cut" /opened up for oversize springs, no Z expert by a long shot but they sure looked stock to me.

Mortec says the same thing....I would agree Colvine may be wrong, but Mortec surely would have corrected any typo being a online site that can be corrected with a key stroke.

3947041....69-70...302/350......"Right angle" casting identifier, 64cc chamber, accessory holes, good HP head


I will take this to pm with Rob, but just so we are clear I am very honest and dont sell Junk, and if I dont know about something I tell ya up front if its junk or what ever. I also will take back anything from a member on this site minus shipping if they think they dont like whatever they picked up.

no offense taken, this is just for all the lurkers that dont speak up much I dont want them wondering wtf?? about me.

Bud.