72 TA : New Project

Chateau Slate 66 · #1 02-21-2008, 10:34 PM

I would assume that he is talking about an air powered jig saw such as this:

**njsteve** · #2 02-29-2008, 02:35 AM

A little more progress on the trunk and driver's quarter panel:

**njsteve** · #3 03-05-2008, 02:17 AM

The roof. It seems that whoever repainted the car many years ago thought that taking the old decal stripe off the roof was a bit too labor intensive, so they just bondoed it over, repainted it, and then applied a new decal on top.

It took a bit of extra work to get the roof flat again.

**njsteve** · #4 03-05-2008, 02:20 AM

More driver's quarter work.

Verne_Frantz · #5 03-05-2008, 04:05 AM

Progress, progress, progress. Remember, you have an offer of an extra pair of hands if needed after it comes home! Just make sure the coffee is on.
Verne

**njsteve** · #6 03-05-2008, 04:50 AM

Thanks for the moral support, Verne

**MosportGreen66** · #7 03-05-2008, 05:30 AM

Dust in a body shop is inevitable, but I feel so bad for the bottom of that TA... you slaved over every last detail... Does look straight though Steve!

-Dan

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.