Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|
|
#1
04-24-2004, 10:32 PM
|
||||
|
||||
Re: BE axle Posi unit...
I guess I'm confused. Colvin's book says that a posi with gearing of 3.90:1 and up was an Eaton 4-series, with no mention of anything special for COPO's (p.303). This was the casting that I attached before. Cunneen makes no mention of the carrier guts being special. Attached is a photo of the inside of my carrier. It came out of my BE rear end. It is quite possable that it was swaped out sometime in the past, but I have no history of the car prior to 1989.
Thanks for your help, as I am now as curious as Mark. Andy
__________________
 COPO 9561/9737 M40 X11D80 13.37 @ 105.50 on pump gas,drove it to NATL TRAILS and back [email protected] SCR22 
|
|
#2
04-24-2004, 10:56 PM
|
||||
|
||||
|
Re: BE axle Posi unit...
This is the ring gear prior to dissasembly.
Andy
__________________
COPO 9561/9737 M40 X11D80 13.37 @ 105.50 on pump gas,drove it to NATL TRAILS and back [email protected] SCR22
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
