![]() Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
#1
|
|||
|
|||
![]()
Was the crossram car a JL8 as well? At least it's good to see cars selling still.
__________________
69 Z28 JL8, #'s match - being restored |
#2
|
|||
|
|||
![]()
Charlie,if you can.....keep updating us on stuff...and tell Mike not to worry..I will watch his stuff ! I hope he left keys so I can start them up and charge the batteries.
__________________
Don't mess with old farts - age and treachery will always overcome youth and skill! Bullshit and brilliance only come with age and experience. |
#3
|
|||
|
|||
![]()
The 69 Yenko at Russo-Steele has alot of problems,I was at Kruse and Silver auctions this weekend and will be in Scottsdale all week for the Barret-Jackson, and the Russo-Steele this weekend. The 69 Yenko was certified by Ed Cuneen in 1998 when it was owned by Lee Dobbs. Ed also did an inspection and the guys at Russo-Steele faxed me a copy of both. It doe NOT have the origional drive train and both quarters have filler on them.It does have some paperwork with it , the MSOand copy of first title.
|
#4
|
|||
|
|||
![]()
Thank you and welcome Souperhigh! Please keep us posted..I myself am quite curious to hear the auction results as I bet we all are.
__________________
Bill O'Brien 1974 Jeep CJ5 - 304 V8, Edelbrock Intake, Holley 650, MSD Ignition, Patriot Headers |
#5
|
|||
|
|||
![]()
The 69 Yenko belongs to a friend, so you guys be nice. I looked at it from the underside yesterday. It is having a new engine installed that happens to be a COPO. The front code is TO512MN, the vin down by the oil filter is 9N647820..Anybody know where that car is ? The crank is standard polished with One under bearings, Aries Pistons, balanced etc. Nice engine. Also has a new Centerforce clutch. No Smog, has headers. Floors are nice but shifter hole has been hogged out and at one time a driveshaft let loose and beat up the tunnel at the rear end of shaft.
__________________
...... |
#6
|
|||
|
|||
![]()
Boy could I use that engine, my COPO is a 4 speed with an 05C build date VERY close in serial number. Wes
|
#7
|
|||
|
|||
![]()
We had a customer that could have used that block as well. We were told that it would be available since it was so far out from the build date of the Yenko. O well, that's not the first time we lost something and it won't be the last...BKH
|
![]() |
Thread Tools | |
Display Modes | |
|
|