Go Back   The Supercar Registry > General Discussion > Technical & Restoration


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #4  
Old 08-26-2025, 09:13 AM
bergy's Avatar
bergy bergy is offline
Yenko Contributing Member
 
Join Date: Feb 2005
Location: Pennsylvania, Florida
Posts: 2,835
Thanks: 914
Thanked 1,529 Times in 410 Posts
Default

My ‘67 hood pins were installed in the hood leveller location. Factory leveller nut in the rad support was drilled out to accommodate larger diameter hood pins. Early fiberglass hoods were pretty weak down the center. So, you’ll often see the hood pins moved inboard quite a bit.

Picture of the rad support pre-restoration
Attached Images
 
Reply With Quote
The Following User Says Thank You to bergy For This Useful Post:
dykstra (08-26-2025)
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 06:18 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.