Factory installed fuel pump gasket 1969 396

[daveg]

Getting closer.
The FP gaskets with "GM" and "Q" have 3/8" holes.
The ones with 5/16" holes have "GM" and "8".

This is obviously a very small database.

Timing cover gasket is same stuff.

Still looking for pan gaskets like this.

[napa68]

Love the work you are doing here Dave

[daveg]

Originally Posted by napa68

Love the work you are doing here Dave

She thinks I am a bit wacko but this digging for stuff- info is fun.

Some must remember the pain with getting pan rails clean if you were the first person to remove a 69 396 oil pan.

Same on the silver valve cover gaskets.
They ended up in a jillion chunks everywhere.

Then you put the rubber ones in and of course leaked.

[67since67]

Originally Posted by daveg

Some must remember the pain with getting pan rails clean if you were the first person to remove a 69 396 oil pan.

Same on the silver valve cover gaskets.
They ended up in a jillion chunks everywhere.

Wire wheel on the bench grinder is your friend...

Done this at least a thousand times beating warranty flat-rate in the dealership a million years ago.