04-08-2025, 02:54 PM
|
|
Yenko Contributing Member
|
|
Join Date: Aug 2006
Location: New York - USA
Posts: 1,316
Thanks: 180
Thanked 108 Times in 65 Posts
|
|
Quote:
Originally Posted by 169indy
For the Sake of discussions. What is the wrench size on the nut flats and then the threads sizing. I wonder if the replacements are inferior to the Orig design? & can a Guy take Cone style and TIG weld a appropriate sized Jam nut in place for a working option.
I cross threaded one of my Origs as the "J" part of the nut was 'Sprung' which lead to miss alignment of the starting thread and caused a problem that I quickly corrected by NOT forcing it and removed and tapped it out and was really careful starting the bolt again.
I might be able to source one or two factory ones if you are in a jam, but the ALL you can take might be a reason to start fabbing these, if the Cone are just a disaster
Jim
|
9/16 hex.
|
Threaded Mode