Big block Chevy Header I.D. - The Supercar Registry

01-10-2025, 01:52 AM

Chuck_Burg Chuck_Burg is offline

Yenko Contributing Member

Join Date: Feb 2019

Location: Long Beach, CA

Posts: 590

Thanks: 632

Thanked 1,113 Times in 289 Posts

I would have needed to "clearance" them if i were to use the stock starter. I used a Mini Starter and they fit without any issues. Only area of minor interference was the lower steering column bearing retaining clamp. The nut contacts the #3 header tube when the pipes get really hot. I need to dimple the tube there a little....

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT. The time now is 07:27 AM.

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.