Correct looking exhaust tips 70-72 Corvette

[olredalert]

Originally Posted by Lynn

Questions for C3 Corvette Gurus.

Thinking about Tony's Kustom Headers and sidepipes for my 70 LT-1.

Also considering going back with an original style exhaust system, sans smog. I have the correct exhaust manifolds, but NOTHING else in the exhaust is correct. Checked with Eric Gardner (site sponsor) about a correct looking exhaust system to include the swaged ends on the downpipes.

Gardner has everything EXCEPT exhaust tips. He said he was not aware of ANY correct aftermarket tips available.

Apparently the originals are chromed steel. Repops are stainless, which will obviously last longer.

1. Does ANYONE make the correct tips?
2. If not, does anyone make correct LOOKING tips.
3. If I go with sidepipes, what do I do with the two cutouts in the rear panel? Bill S, what did you do? Seems it would look a bit weird with the unused cutouts.

----Don't do what I did, Lynn. Just had the holes fiberglassed over when I changed the color from yellow to a custom maroon.....Bill S

[Starship]

A couple of points here.

Tips with part numbers stamped into them are service replacements, not originals.

The photo that NAPA68 posted is the correct one for 1970 ONLY. 1971 (give or take a few possible cars) and 1972 tips would also have a welded seam down the center of the bottom surface along with the welding around the rear perimeter. And no part numbers.