1967 Camaro assembly line

[Keith Seymore]

Originally Posted by Too Many Projects

In October, 1972, I started working at the St. Paul Ford plant. As the low man on the seniority list, I got moved all over the plant. I, eventually, got settled starting on the F line in the morning and was lucky if I got to stay there all day. We were working Saturdays and on one, I was pulled from the truck line very soon after starting and sent to the car line, where I had to thread the trunk light in and a couple other jobs AND tear a build sheet off a printer and get it taped to the correct vehicle. It was a very fast paced I was having difficulty keeping up and told the line foreman I either needed more time with the trainer or he needed to get someone with more experience to do the job. I even told the relief man that when it was time for my break. Nope, you stay right here. Wasn't long after that, I heard a loud, angry discussion from the line foreman and someone from the office and they came back to me. I had missed a build sheet and they had 3 bodies on the floor at the marriage line with the chassis... both the guys were shouting at me and I reminded the foreman that I had told him I wasn't able to do the job and he insisted I stay on it. The guy from the office blew a gasket at that and off they went. I had a trainer next to me in a matter of minutes, but lunch break came and I was just so pissed and frustrated, I went out to my car and went home. Monday is a whole 'nuther story...

I was just thinking the other day about an incident we had on the Volt program.

In the Hamtramck plant the first place the new content would hit would be the IP line, where the dash assembly was built up and the instrument cluster, radio, HVAC controls, etc, would be installed. We would hang out there in order to get an early look at how the options were broadcasting.

One time I was standing there with my plant host, the plant planner, and the line stopped. Having grown up on the assembly line I’m a bit sensitive to when it goes down so I cut into our conversation abruptly and asked “why are we down?”

“Uh – we’re on break” he said, looking around nervously.

“Good” I said. “I wanted to make sure it wasn’t my fault”.

HA HA, right?

In about two minutes one of the other engineers comes running over, all in a huff. “SEYMORE!” he says. “We’re not on break; we're down on the IP line and IT’S YOUR FAULT!”.

A bit surprised at this sudden change of status I sauntered over and there was a crowd of neckties around the radio install. The line superintendent (the foreman's boss) was there and took the opportunity to show boat a bit by ripping me a new one about engineering changes, and how stupid engineers are, and how disruptive temporary changes are, etc. It was in that supportive environment I had to figure out what was going on. It seemed that one of the inspection features had the line shut down, the symptom being that as the operator tried to scan one of the bar codes the reader didn’t recognize it as the right part and stopped the line. After a couple minutes I asked her to show me what she was doing.

“I’m scanning this” she said “but it won’t go.”

That’s when I noticed she was scanning the wrong bar code; Operator error. I showed her the uplevel part number and code and when she hit that with the laser reader “…whirrrrrr” everything spun back to life. The crowd quietly disbursed and everybody went back to whatever they were doing.

I just thought it was funny that it was "wasn’t my fault/was my fault/wasn’t my fault".

Do you suppose I ever got an apology from the superintendent for improperly, inappropriately and incorrectly dressing me down in front of a whole passel of plant and engineering personnel?

Of course not.

K