Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|
|
#1
02-10-2022, 07:53 PM
|
||||
|
||||
Intake fittings...
He has taken them both out...he heated them up and they came out ok.
So, what is the process to re-install the non-threaded nipple??
__________________
02 Berger 380hp #95 Lots of L78 Novas Join National Nostalgic Nova! 70 Orange Cooler 69 Camaro 
|
|
#2
02-10-2022, 08:52 PM
|
|||
|
|||
|
I would say start by putting the fitting in the deep freeze for 3 or 4 hours then heat the manifold up until water bubbles off. Put some light lube on the fitting and grab the fitting with a pair of vice grips with a light touch. Protect the fitting from the vice grips with some old gasket material. wiggle the fitting down, have a small block of wood and a hammer handy in case you have to gently tap it down
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
