Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Members List | Calendar | Become a Paid Member | Search | Today's Posts | Mark Forums Read |
|
|
|
Thread Tools | Display Modes |
|
|
|
#1
04-14-2021, 01:19 PM
|
|||
|
|||
I can imagine it in the vintage-style Pacer Rallye rims that I saw on 4wheelonline. Awesome progress! The car looks lovely!
|
| The Following User Says Thank You to touspude For This Useful Post: | ||
X66 714 (04-14-2021) | ||
|
#2
05-02-2021, 05:52 PM
|
||||
|
||||
|
I haven't posted in a while. Nothing to photograph. Going through problems like HuggerSS. Found the double crimped brakes hoses don't always fit like the singles. I bought older Raybestos from e-bay. On the RH side I had to remove a little flashing on the caliper & find a copper washer that was .020 thicker. Put trans fluid in the TH400 & I have a leak where the speedo adapter goes into the tail shaft. I go for the vinyl top install on the 5th of May. Not sure about the clips for the top mouldings. Just been working on finishing up. One piece at at a time
I was approved for MCACN so I'm looking forward to that...Joe
__________________
1968 Z/28 Corvette Bronze. Black Hounds Tooth. 02E Los Angeles born 3/13/1968 pnt OO 1969 SS396 Yellow/Yellow 08E Norwood born 8/28/1969 pnt 76E 1970 'cuda Moulin Rouge, 440-6, 4 speed
|
| The Following 7 Users Say Thank You to X66 714 For This Useful Post: | ||
big gear head (05-03-2021), napa68 (05-02-2021), NorCam (05-02-2021), PeteLeathersac (05-02-2021), RPOLS3 (05-03-2021), travlnz28 (05-03-2021), Xplantdad (05-06-2021) | ||
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
