Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Members List | Calendar | Become a Paid Member | Search | Today's Posts | Mark Forums Read |
|
|
|
Thread Tools | Display Modes |
|
|
|
#1
03-07-2021, 03:03 PM
|
||||
|
||||
I've TIG welded cast iron several times using N99 nickel wire, pre heating and then allowing it to cool slowly. Nickel wire is very expensive. I've laid coarse sand paper on cast parts and hammered on the sand paper to give it a cast appearance. Using a knurled breaker bar handle to hammer on parts can give a cast appearance.
__________________
Freddie 1969 Camaro RS/SS396 (427) 4 speed 
|
| The Following 2 Users Say Thank You to big gear head For This Useful Post: | ||
earntaz (03-07-2021), PeteLeathersac (03-07-2021) | ||
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
