Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Members List | Calendar | Become a Paid Member | Search | Today's Posts | Mark Forums Read |
|
|
|
Thread Tools | Display Modes |
|
|
|
#1
10-02-2019, 01:33 AM
|
|||
|
|||
Couple of quick questions if anyone can help. There is a new engine wiring harness on the car but the lead for the oil pressure sensor has a round female end and the pressure sensor itself has a male blade. Pictures I see on line of the sensor for a car with gauges shows a sensor with a male blade like I have.
Also should there be a 45 degree brass fitting between the engine block and the pressure sensor. Hopefully someone has more knowledge or a better memory than I do. Thanks for all help ! 
|
|
#2
10-05-2019, 10:45 PM
|
||||
|
||||
|
The round end for the oil sensor is correct. Oil sensors with the flat terminal like you have are not correct. You should also have the 45 degree brass fitting that the sending unit screws into. I don't have pictures to show you but I'm sure someone here can come up with them.
__________________
Robert _______________ 1969 Chevelle SS396 L78 M21 4.10 2023 Stingray Coupe Z51 Last edited by tunes; 10-05-2019 at 10:49 PM.
|
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
