Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Members List | Calendar | Become a Paid Member | Search | Today's Posts | Mark Forums Read |
|
|
|
Thread Tools | Display Modes |
|
|
|
#2
04-24-2018, 11:16 PM
|
||||
|
||||
So I am wrestling with which air cleaner to go with. I see a bunch of round “fly-eye” a/c’s used and was hoping to find something different that looks good. The below triangular type popularized by Weiand, Ram-Flo, Edelbrock, etc. may be a bit late to the game for my ‘69 wrt when they were introduced, so I will have to consider that (suggestions are welcomed). If I use this Ram-Flo I will have it replated so it pops. Regardless of which I choose, I want to address PCV on the passenger side of the engine and will most likely use carb vacuum to take care of it. So, just like I did with the Roof Deuce I used M22Mike’s (Mike A) inspiration to create a junction between the VC and the air cleaner and I thought I would post one way to take care of this. I like simple so I used copper and steel so I could get away with soldering. I may paint this black eventually although there is a definite steam punk vibe going on now...
__________________
Sam...  
Last edited by mockingbird812; 04-24-2018 at 11:41 PM. Reason: Spell check 
|
| The Following User Says Thank You to mockingbird812 For This Useful Post: | ||
SS427 (04-26-2018) | ||
|
#3
04-25-2018, 12:03 AM
|
||||
|
||||
|
Dang.....your hired...
|
| The Following User Says Thank You to m22mike For This Useful Post: | ||
mockingbird812 (04-25-2018) | ||
|
#4
04-25-2018, 04:00 AM
|
|||
|
|||
|
----JFO, (just for me) absolutely better than Fly-eye! Hope the haters don't hate......Bill S
|
| The Following User Says Thank You to olredalert For This Useful Post: | ||
mockingbird812 (04-25-2018) | ||
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
