Quote:
Originally Posted by 169indy
We use heat to obtain thermal expansion of the frame yoke in order to get some expansion & clearance to aide remove the laminated core from Submarine AC & DC motors. Gentile application of flameless heat source will work as a tip or trick.
JIM
|
Jim - sounds reasonable. Thanks
Ran into another snag: I am just about through dismantling everything and am stumped on how to remove this pin (shown in photo at 2 0’clock position). It appears to be held on by a washer-like piece. It is not a “C” or “E” clip. This pin pivots the lever on the other side of the housing (see 2nd photo, lower right corner) which actuates the washer pump.
Thanks,
04-02-2018, 01:02 AM
Threaded Mode