My Little 68' Driver

[NorCam]

Well...I finally pulled the drive line out of the 68 last week and got around to a test run of the new solid roller motor that will now be going into the 68. Ran it in last night and will do some more tuning later today as I dial in the carb and re-lash the valves. It will be installed soon along with a new Autogear M-22.

Engine Specs:

• Seasoned 010 Block 4-Bolt Main
• Fully Balanced and Blueprinted Build
• Decked .005, Bored & Honed .060
• Moroso Blueprinted Oil Pump w/ Pickup
• Milodon Deep Pan w/ Windage Screen
• GM Forged 1182 Crank Std/Std
• Manley SMR 4340 I-Beam Rods 3/8" ARP 2000
• Manley Platinum 4.060 2618 Forged Pistons 10.5:1
• Lunati 40120528 Solid Roller 254/262 @ .050 582" Lift
• Lunati Roller Lifters c/w HP Oiling
• Trick Flow 7.900 Pushrods
• ProMaxx 200cc Aluminum Heads 64cc Chambers
• Manley S/D Valves with Lunati 1.450 Springs
• Crower Stainless Roller Rockers 1.500
• Edelbrock Victor Jr Intake
• AED Ultra 750 HO Carburetor
• GM Finned Cover c/w Drippers Intact

It'll make a great little screamer for the street and should pull hard through 7500 rpm on the mountain twisty's that I like to run. Let the good times roll I say.