Black L78 1969 SS396 300 Deluxe Post Sedan Found

[kwhizz]

[img]<<GRAEMLIN_URL>>/worship.gif[/img] [img]<<GRAEMLIN_URL>>/worship.gif[/img] [img]<<GRAEMLIN_URL>>/worship.gif[/img] [img]<<GRAEMLIN_URL>>/worship.gif[/img]

[Rixls6]

Things have been progressing slowly, but I should have the rear end done and ready to install by next week.
I had to have a guy at Chassis Service turn the driver side axle tube back into position, as apparently the plug weld broke loose on that side.
We then had them install a new Eaton 4-series posi and a new 4.10 ring and pinion, as well as all new bearings, etc.
Nothing much to see far as pictures go on that.

I also had to straighten and body work the original disc brake backing plates, then Kevin over at Nostalgic gave me a duplication of galvanizing like they looked in `69.
The floor plug is original galvanizing for comparison.

[Xplantdad]

Looks good Rick!

[Ryan1969Chevelle]

Is that the original KK? Now back to original?

Ryan

[Postsedan]

Rick,

Looks very nice [img]<<GRAEMLIN_URL>>/biggthumpup.gif[/img]

Dan

[Rixls6]

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Ryan1969Chevelle</div><div class="ubbcode-body">Is that the original KK? Now back to original?

Ryan </div></div>

Yes we were able to save the original KK rear, but it took a bit to make it right again.

[Ryan1969Chevelle]

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Rixls6</div><div class="ubbcode-body"><div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Ryan1969Chevelle</div><div class="ubbcode-body">Is that the original KK? Now back to original?

Ryan </div></div>

Yes we were able to save the original KK rear, but it took a bit to make it right again. </div></div>

Well worth it!!

A real highway cruiser gear:-)

Ryan

[Rixls6]

My JD code engine is done, and will be dyno-run this Tuesday. (Finally!)
Video to follow afterwards.

[Ryan1969Chevelle]

Looking forward to the dyno run!!!!

I am planning to dyno/break in my engine when the time comes. Makes sense to me!

Ryan

[69 Post Sedan]

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Rixls6</div><div class="ubbcode-body">My JD code engine is done, and will be dyno-run this Tuesday. (Finally!)
Video to follow afterwards. </div></div>

[img]<<GRAEMLIN_URL>>/biggthumpup.gif[/img]