Derusting a flywheel.

[68l30]

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: [email protected]</div><div class="ubbcode-body">What the machine shop does is, it gets it clean and then trues it up with a resurface. Its worth the 50 beans to me for that service! </div></div>

^^ That and it ain't worth f'n up a clutch disc and doing the job again... [img]<<GRAEMLIN_URL>>/scholar.gif[/img]


BIG

[GaryC]

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: 68l30</div><div class="ubbcode-body"><div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: [email protected]</div><div class="ubbcode-body">What the machine shop does is, it gets it clean and then trues it up with a resurface. Its worth the 50 beans to me for that service! </div></div>

^^ That and it ain't worth f'n up a clutch disc and doing the job again... [img]<<GRAEMLIN_URL>>/scholar.gif[/img]


BIG </div></div>


Totally agree. This is something I hated messing with anyway if you don't have a lift. I have done a few with and without one and would rather do it once without a lift.

Thanks guys, I believe I know what my plan is for the flywheel now. All good info, I appreciate it. Do it once and do it right the first time. There is a local NAPA and a Manlove in my area I can take it too, but I believe it goes out to someone else from there, I'll have to check on that. Heck it may even go out of state if that is actually done.

[Salvatore]

Sounds good Gary! Case closed on the flywheel. NEXT.........