The New Project: Part Deux!

[njsteve]

I spent some time last night soaking the intact set of wires in some purple stuff and them scrubbed them in soapy hot water. They looked pretty good. No cuts or slices anywhere. I was able to pull the spark plug wire boots back to see the spark plug terminals. Now I see why they tossed this wire set. Almost all of the spark plug leads were broken and/or replaced. The original end is a 135 degree bent end. I ordered some replacement terminals from Taylor Wire and will replace them all.

The funny thing was that all I could find was 45 degree terminals...that was until I figured out that one manufacturer's 45 degrees is another manufacturer's 135 degrees. Add 135 and 45 and you get 180. :-)







You can see the silk screened numbers and "Packard TVR Suppression 1Q-73"