Lakewood roll bar

[waynemiller]

The pic in this thread is my car, we had to cut down the main hoop by about 2 inches amd realign the rear bar. We also made a mount out of flat bar, so we would not have to cut the rear seat. I will post a couple of pics. I also just sold a 3 point yesterday on craigslist.

[Musclecarkid]

I believe the rear support bar goes between the upper and lower rear seat cushions and bolts to existing seat belt bolt hole. Additional holes may be required, but not necessary for show purposes. Camaro and Chevelle bars fit with no modification to the rear seat. Note rear support bars are different just as the front mounting feet are different. Some rear bars have slight bends to make the roll bar sit correct in the car,

[PxTx]

Kev, can you throw up a pic of your "chomie" bar?