Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Members List | Calendar | Become a Paid Member | Search | Today's Posts | Mark Forums Read |
|
|
|
Thread Tools | Display Modes |
|
|
|
#1
|
||||
|
||||
|
I was just gonna ask that. Mine is an M22. Mark B has an original low mile Z with the same stripes as mine. Not sure what tranny or rear is in that car.
__________________
1969 Z28 1972 Corvette |
|
#2
|
||||
|
||||
|
1969 Z/28 M22 4:10
I am guessing that it is striped white (faded and yellowed) and orange. These are the only 2 marks that I can see on the driveshaft. If there were more I'd think they would be visible as these are very clear. ![]()
__________________
1969 Z28 1972 Corvette |
|
#3
|
||||
|
||||
|
Looks the same as my 67 z/28 with M21
The first marking towards the yoke is where something was rubbing and isnt a paint mark. I think ornage and white was pretty typical of manual trans cars ![]()
__________________
1969 Camaro RS/SS Azure Turquoise 1969 Camaro Z/28 Azure Turquoise 1984 Camaro z/28 L69 HO 5 speed 1984 Camaro z/28 zz4 conversion 1987 Monte Carlo SS original owner |
|
#4
|
||||
|
||||
|
another
![]()
__________________
1969 Camaro RS/SS Azure Turquoise 1969 Camaro Z/28 Azure Turquoise 1984 Camaro z/28 L69 HO 5 speed 1984 Camaro z/28 zz4 conversion 1987 Monte Carlo SS original owner |
|
#5
|
|||
|
|||
|
Here's how mine turned out, 11 inches from the end of the driveshaft. With the flash pic the driveshaft looks two-tone, think that was just where I had it masked and now dustfree. Cant see it naked eye. I just masked a 3/4 inch wide stripe 11 in from the end, spraypainted it. Waited a few hours, masked the next stripe and repeated the process. Could also do it with one of the foam brushes. Car was on jackstands and just rotated the shaft by hand.
![]()
__________________
Dave ![]() |
![]() |
| Thread Tools | |
| Display Modes | |
|
|