Here are a few pics , there is some light surface rust spotting on it which I did not clean, do not have any of the correct cleaners handy for removing it without using abrasives handy which I won't use on anything like this.
The tube is almost exactly 1.5" from the top spot weld to the end of the dipstick. Hopefully you can see the wording clearly enough in the scans otherwise I will have to wait until I can clean it properly or I can find the good camera that does macro, used a scanner for these.
Thanks again guys with the ID help. :cheers:
08-29-2009, 01:19 AM
Re: Dip Stick Question
Threaded Mode