Trim Tag Rivits

[bergy]

Just FYI - The center of the rivit on the tag pictured has seam sealer protruding through it. The center was presumably open before the seam sealer was applied.

[RamAirDave]

I've never been in any situation in which trim tag r/r was needed during resto. Maybe I've just been lucky, but I would have some serious reservations on ever doing so.

Having one chem-dipped isn't an option we would consider, and the ones I've had blasted I've covered every tag/# with several layers of duct tape as well as repeated instructions to the blaster not to go near it. When we had (the first and only) car soda blasted, they didn't listen very well and hit the tag. It looked damaged initially, but turned out okay.

Non-issue now as I do the blasting myself now (again). And if its built up with paint, just strip the paint as BH mentioned.

[P.J.]

If you have documents and a history of the car and you need to replace the trim tag rivets its ok with me.You are lucky if your rivets and tag are ok after 40 years,
but what iffffff.I have seen rivets that were about to fall off from corrosion. Do you chance loosing the trim tag???
Surely if your cars history and documents are ify then yes
removing the tag is a no no.
PJ