143 Blueprint Cam Install

Home: Goto Homepage.
Subscribed: See all threads you’ve posted in or started.
Today's Posts: Posts made today. Bold = unread.
New Posts: Shows all unread posts since last visit.
New Thread: Newest threads by creation time.

**kwhizz** · #12 05-15-2009, 02:44 AM

Forgot to mention that I used the Joe Gibb break-in oil along with the supplied lube on the cam......I set the valves with the Intake off and brought the engine to TDC...before putting the Intake back on I spread the rest of the Cam lube on the Lobes thru the opening in the lifter valley....That way I didn't have to turn the engine over at all before starting , this kept the Maximum lube at the point of contact at start-up....Back filled the Carb thru the Vent tube also.....It started after about a half a revolution and took it right up to 3000.....

Ken

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.