Quick SBC cylinder head question

Home: Goto Homepage.
Subscribed: See all threads you’ve posted in or started.
Today's Posts: Posts made today. Bold = unread.
New Posts: Shows all unread posts since last visit.
New Thread: Newest threads by creation time.

**iluv69s** · #1 04-20-2009, 03:47 PM

the 292 "turbos" were angle plug.....they also made a 492 which was angle plug also I believe...both these were steel....I also have a set of angle plug o-dash part number alum chev. heads, but they are from 1963 I believe..then there is the "hemi" angle plugs from 69 which were aluminum. What heads do you have Charley? What year are they?

**Charley Lillard** · #2 04-20-2009, 06:42 PM

Mine have bolt holes on the end of the heads but I don't remember if they have dates. They aren't here to check. Part # is stamped on the end of each head.

**Charley Lillard** · #3 04-24-2009, 06:58 AM

I did find I have a set of Bowtie angle plug heads if anybody needs them. The Bowtie heads came later than the 292 turbos.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.