67 chevelle BB motor mount help!

[jasonL78]

Eric,

Thank's for replying I have the passenger side all the way down also. But why are the top 2 holes slotted and not the bottom hole. This may be my problem. My car was a small block car so are BB car's suposed to have all three holes slotted on the passenger side frame? Was your car an original BB car?

Jason

[VintageMusclecar]

Mine is an original BB car, and all 3 holes on the pass. side of the frame were slotted.

[MotionPerformance67]

ok, I ran into this problem before with a customers 67. I ended up taking a 6ft prybar with a tape covered end so as to not damage the paint and wedging it in between the frame and the engine bracket from the front and prying up while the engine sat on the mounts, worked perfect and the bolts slid right in...

[jasonL78]

Good Idea that may be next!

[a-body]

A pry bar might work good to get them in, but how are you going to remove them if you need to. I'm glad mine weren't put in that way.
A friend had the same problem with his Chevelle. When I stopped over to help, his looked just like your picture. It turned out he had the wrong motor mounts. They look similar, but BBC motor mounts are slightly different than SBC motor mounts. He swapped them out, and it went right in. Good Luck
Gary

[MotionPerformance67]

[ QUOTE ]
A pry bar might work good to get them in, but how are you going to remove them if you need to. I'm glad mine weren't put in that way.
A friend had the same problem with his Chevelle. When I stopped over to help, his looked just like your picture. It turned out he had the wrong motor mounts. They look similar, but BBC motor mounts are slightly different than SBC motor mounts. He swapped them out, and it went right in. Good Luck
Gary

[/ QUOTE ]
I guess I must of did something wrong by slightly tweaking the stamped in China bigblock engine brackets , because the motor has been in and out of his car a few seasons now and the bolts seem to just slide right in. My guess is when the brackets were stamped as in most overseas cases, were a mile off. He ran the same style engine mounts as that are pictured but later switched to a Moroso solid style and guess what..they slid right in..

[jasonL78]

Success the motor and transmission are installed! I took Eric’s advice and made the lower hole on the passenger side frame about a ¼ of an inch lower so all three holes were slotted and the motor mount bolt’s went in with no problem. Thanks Eric.

Ok now onto the next problem I have. The stock cross member don’t line up with the turbo 400 transmission mount. I am sure someone put a turbo 400 in a 66-67 chevelle before? What my father and I are thinking of doing is moving the mounting tab for the transmission mount to the backside of the cross member. I will take some pictures when we finish it. Anyone one have any idea’s?

Second problem but I think I know the answer. My car was a power steering car and I thought I would be able to use a Saginaw pump set up but it hit’s the steering box. On 67 BB cars what does the power steering set up look like anyone have any pictures to share with me? Wasn’t the reservoir on the driver’s side inner fender?

Jason