Go Back   The Supercar Registry > General Discussion > Lounge


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #8  
Old 05-16-2025, 03:14 PM
Lynn Lynn is offline
Yenko Contributing Member
 
Join Date: Feb 2005
Location: Oklahoma
Posts: 7,763
Thanks: 89
Thanked 3,567 Times in 1,505 Posts
Default

That is what I figured Jeff. Planning to use on the dual four engine. I like that I can remove the bottom and re-clock if for clearance.

Original dual quad fuel pumps bring big $$$. I think I paid like $40 for this one many years ago.

Chuck:
I know some consider this really bush league, but might be worth a shot IF you have a pump that can be disassembled. Not sure it would work with a fully assembled pump. I have had good luck on a few cast aluminum parts painting with a high heat aluminum cast finish paint. I think the one I used was one with ceramic (at least that's how it was advertised). I blast the part with fairly course sand or coal slag, blow it really clean; spray it, and then bake it in the oven at 450 degrees for about 30 min. The surface is incredibly scratch resistant.
__________________
Don't believe everything you read on the internet ... Ben Franklin
Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 08:16 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.