LAKEWOOD ROLL BAR 3 POINT HELP

[STREETRACE69]

Thanks for the help guys!! The complete bar I have is out of a Dodge/Plymouth from what I can gather. It is 100% complete including the mtg hardware for the pads. They had 3/4x4" lugs that they sandwiched the floor in between.

They list as one bar but not sure how it would fit with mtg brackets as without any it is up against the headliner? Also look at the 1st bar pic and then the other red one. The passenger side of the hoop where it turns down to meet the floor is a lot shorter on one than the other. Mine is the longer version. The width appears of if it was being welded on pads.

I will post pics and measurements today of what I have. Honestly it is a super easy bar to replicate. I might just make one and sell this one to a Mopar restorer I think they used them in the Hemi Darts??If it was 2 years ago I would be going to Disney on the sale.