Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
#11
02-27-2018, 02:53 PM
|
||||
|
||||
Is the measly cost savings reeeallllyyy worth risking your engine over?
I wouldn't run a cast core roller even at gunpoint. I'd run a flat tappet first, by a long shot. When it comes to a roller, in my book: Billet core, iron gear pressed on, slide it in, measure & degree it and rock & roll. Just my $0.02 worth. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode