72 TA : New Project

[njsteve]

I then raised the car and loosened the tie rod ends and turned both tie rods an equal amount to get the front wheels to match each other as well as the steering wheel when it was in the correct position.

It took several test drives and subsequent chalk tracings and readjustments, to get the wheel exactly straight but in the end I got the toe-in to 1/8" (the factory spec is 3/16" + or - 1/16&quot.




By the way, I did partially disassemble the old tilt column to get the original turn signal switch out in order to use it in the new column as it had the correct color-coded wires in it that matched the dash wiring harness. During the disassembly I found that the upper bearing had come apart in the tilt column, hence the ringing sound of the races rattling against the housing.