Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
|
|
Thread Tools | Display Modes |
|
#1
03-20-2014, 11:04 PM
|
||||
|
||||
Intake Manifold Vacuum Port/Brass Fitting SB
This is an original vacuum fitting elbow for a that screws into a threaded hole at the rear of your cast iron intake manifold for a SB chevy engine. Should not be used with an aluminum intake because I believe those fittings were different from the factory. Anyone can correct me if I'm wrong on that. Probably used on multiple years but this particular one came off my '69. It is used in conjunction with a steel power brake tube attached to a hose that ran to the brake booster. The threads are in great shape. The overall condition is pretty good but I would suggest having it replated for show. The brass fitting however is a brand new unused reproduction made in the USA. The tube is not included. *Asking $35 w/shipping included to lower 48 states. PM me with any questions. Thanks.
   
__________________
I currently own a 1969 Camaro SS350. Although the original drivetrain is long gone, this 4/speed car has a March '69 HC coded block with #041 heads. The transmission is an M20 Muncie #660 case and the rearend is a BS coded 12 bolt posi. Built in Van Nuys. 
|
|
#2
04-01-2014, 11:08 AM
|
||||
|
||||
|
Re: Intake Manifold Vacuum Port/Brass Fitting SB
Bump...
__________________
I currently own a 1969 Camaro SS350. Although the original drivetrain is long gone, this 4/speed car has a March '69 HC coded block with #041 heads. The transmission is an M20 Muncie #660 case and the rearend is a BS coded 12 bolt posi. Built in Van Nuys.
|
Linear Mode
