37 Ford LS2 Continuation thread

[kwhizz]

First off.............The "Tangle" of wires is disappearing.........



And I have all the outside A.C. and heater lines crimped and assembled.......the break in the two smaller lines in the pic is where the Filter/Drier goes.........



Also got the gas tank vent put in.......I positioned it high in the wheel well opening where it will be covered by the fender and high enough to do the job.....It has a small slotted screened area that is facing away from where the tire would throw stuff that is where the vent opening is





As I was digging around looking for some parts today I came across the coil covers and just for the heck of it I put them on....I didn't think they would fit, and they dropped right on.........



Now............At this point Dave said "Let's see if it will start"..........Hit the key and it started Imediately.....Wow!!.......I didn't have much faith in the engines starting with the complexity of the wiring and everything else.....Just go's to show that Dave and the GM Engineers know what they are doing......Even the drive by wire gas pedal worked

Ken (with a smile on my face)

[mockingbird812]

Congrats Ken! Looking great and coming along!!!

"Ken (with a smile on my face)"

[Xplantdad]

Awesome! Keep smiling

[Plowman]

That is COOL!

[WILMASBOYL78]

is this turd done yet..??

[kwhizz]

Spent the day today getting the car down on the ground and and setting the pinion angle.....Wheels and tires are still not in..........



Got the steering linkage in and finished



Picked up all the new side and rear window glass also....Next week we will get all the inside hoses hooked up, get the heat and defrosters hooked up.....Radiator Hoses and get the Door internals installed and put the doors on.....Off to the upholstry shop in a week



Ken

[Salvatore]

Man-O-Man Ken, Looks great and even runs.

[kwhizz]

In addition to making a bunch of parts and gaskets to clean up and seal the installation of the windshield wipers (install and pic's tomorrow) I got the air intake pretty much finalized, after I get the front sheetmetal installed I will be making a cold air box to draw outside air in thru the Hood sides.........Lot's of misc parts coming in this week to finish everything up.........






Ken

[budnate]

nice , your getting close to firing it up, no rod is complete without a drive around the lot sitting on the milk crate.

[Xplantdad]

The air intake looks great...

I remember all of the looking at SEMA for just the right part...