Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Members List | Calendar | Become a Paid Member | Search | Today's Posts | Mark Forums Read |
|
|
|
Thread Tools | Display Modes |
|
|
|
#1
02-16-2006, 05:49 AM
|
||||
|
||||
1970 Camaro Rear Bumper Guard
I'm in need of the two bolts and washers that hold the bottom of the bumper guards to the rear end panel on my '70 Z28. Thanks.
|
|
#2
02-17-2006, 01:53 AM
|
|||
|
|||
|
Re: 1970 Camaro Rear Bumper Guard
This is one thats done wrong a lot, the bolts look way to small for the brackets. S B C are the originals on my car, not sure how correct you want to be.
__________________
Jack Seymour 1970 Z28 Hugger Orange 20K Mile Survivor
|
|
#5
02-17-2006, 03:44 AM
|
|||
|
|||
|
Re: 1970 Camaro Rear Bumper Guard
www.amkproducts.com has similar if not the same 1/4"X 1" Bolt. I have seen a different head marking than Jack's above picture....so long as some G.M. headmark would be OK!
WELLNUT is/was brand of Valance nut of which AMK has on page 70 of catalog, but not sure if O.E.M. Washer useage appears to have been improvised at factory, as not captured or anything special
__________________
Chuck Sharin [email protected] Auburn,WA (30 miles South of Seattle) 70 Camaro R/S Z-28, L-78, R/S SS 69 Camaro COPO "recreation"
|
|
#6
02-17-2006, 03:55 AM
|
|||
|
|||
|
Re: 1970 Camaro Rear Bumper Guard
They are 1/4" and not 5/16"s ?
|
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
