![]() Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
![]() |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Looking for recommendations on who to have restore a Holley carb. I want more than just a Cosmetic job. I want it to work right also.
__________________
...... |
#2
|
|||
|
|||
![]()
The Holley Custom shop is good. Call Jerry MacNeish too. The Holley shop does Q-Jets too F.Y.I.
__________________
Looking for Bill Kuhn Chevrolet dealer badge!!and memorabilia from dealership circa 1967 |
#3
|
|||
|
|||
![]()
Does anyone have Woodruff's phone number?
__________________
1968 COPO/YENKO 9737 Non-Converted |
#4
|
|||
|
|||
![]()
The # I have for Woodruff is 330-799-9479.
__________________
...... |
#5
|
|||
|
|||
![]()
Thanks, Charley
__________________
1968 COPO/YENKO 9737 Non-Converted |
#6
|
|||
|
|||
![]()
Chicago Corvette Supply does a nice job also. They even test it on an engine for no extra charge. The finish they use is the same as the factory.
|
#7
|
||||
|
||||
![]()
Bob Kunz
|
#8
|
|||
|
|||
![]()
Kunz or Craig Woodruff
__________________
Micky Hale Hale Performance Consultants Engine Parts Sales & Service |
#9
|
||||
|
||||
![]()
Those are the best two and there is also Holley carb shop. Just don't send them small pieces such as air cleaner studs, carb studs/nuts, fuel lines, etc. You may not get them back. Also specify needing exact restoration. I got a green choke cam back and my perfect white one was gone???? They took care of it all in the end however.
[Edited by SS427 (05-13-2002 at 12:17 PM).]
__________________
Rick Nelson Musclecar Restoration and Design, Inc (retired) www.musclecarrestorationanddesign.com https://www.youtube.com/watch?v=62r-6vgk2_8 specialized in (only real) LS6 Chevelle restorations |
#10
|
|||
|
|||
![]()
Does anyone know what buiness name Bob Kunz and Craig Woodruff are associated with?
I looked them up on the Internet without success. I have been trying to get my Holley 3160 restored and have called Holley Custom Shop repeadedly without a callback so I finally wrote them. They responded as to the rebuild and refinishing but could not do dyno-jetting nor install my gear drive injector. I am wondering if either of these gentlemen could do this? Thanks for any assistance in this matter. |
![]() |
|
|