cam shaft specs

[Alss]

Hey everyone..have a question/problem. Bought the 69 Z 28..small block 302 solid lifter,all stock but it does not have the stock cam in it.I have no specs for the cam [img]<<GRAEMLIN_URL>>/frown.gif[/img]..no card, part number, make , grind etc. Sounds a little noisey, and I want to adjust them but with no cam card..what do you do? [img]<<GRAEMLIN_URL>>/dunno.gif[/img] Tried measuring the existing lashes but they are so all over the place I dont know where I would start!..plus the numbers I'm getting are what i would consider tight on my BB..avg of .010-.012 intake and .017-.020 exhaust..normal for a Small Block? I do know that it is NOT a stock Z 28 replacement and it is smaller. Previous owner wanted better drivability, and it does run well..but not like it should. I was hoping the valve lash may restore some power. I know I'll wind up putting a cam in it, just saving it for last on my option list. [img]<<GRAEMLIN_URL>>/smile.gif[/img]

thanks