Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
#1
04-19-2003, 09:07 PM
|
|||
|
|||
Stripe Dimensions
I'm looking to duplicate the stripe scheme that resembles a 'T' when you see it from the top. Was there a specific width to the main B/M stripe? Also, since it is pin striped on either side is there a specific width to the pin stripe or for that matter the gap between the main stripe and the pin stripe. Any and all help on this is greatly appreciated.
|
|
#2
04-24-2003, 12:17 AM
|
|||
|
|||
|
Re: Stripe Dimensions
I am restoring a 1970 Motion Camaro I hope to find a Motion car at the GM national at Carlisle. I know of one that might be there. Check with me after 6/17/03
|
 |
|
|
Linear Mode
