Installing headers

[mockingbird812]

So I have the distinct honor of having to remove, recoat, and reinstall my Super Scavenger headers in my ‘69 Chevelle SS ! The original coating was not applied/cured properly and started to fail almost immediately. So, I am looking for the best way to reinstall these headers with the engine already installed. When I installed them the 1st time, I lifted the driver’s side of the engine (after removing the engine mount bolt) to try and gain a bit of room, but had a heck of a time reinstalling the driver’s side engine mount bolt as the headers leave little room in that area and the bolt has to come from the rear of the engine. Has anyone put their car on a lift and inserted Super Scavengers from below. They are a tight fit!

thanks!