1957 Chevy Front Spindle Washer

**Lynn** · #1 Yesterday, 03:39 PM

Kind of an odd ball request.

Any Tri Five owners here with a stash of parts?

Need one spindle washer. OD is 1 and 15/16. ID is 3/4. Mic says 1.940 and .758.

Let me know if you have one.

**Too Many Projects** · #2 Yesterday, 06:18 PM

Quote:

Originally Posted by Lynn

Kind of an odd ball request.

Any Tri Five owners here with a stash of parts?

Need one spindle washer. OD is 1 and 15/16. ID is 3/4. Mic says 1.940 and .758.

Let me know if you have one.

Does that have a tang to fit in the slot of the spindle to prevent it from turning ?

**Lynn** · #3 Yesterday, 06:24 PM

Yes. The 3/4 inch ID does not take into account the tang.

**Stefano** · #4 Yesterday, 07:05 PM

I'll check.

**Stefano** · #5 Yesterday, 07:16 PM

I found a couple. Email shipping address to [email protected]

**Too Many Projects** · #6 Yesterday, 10:10 PM

Good deal that Stefano found some. I would have bet I had at least 1 in my 1970's parts box, but no.

**Lynn** · #7 Yesterday, 11:49 PM

Stephano: you da man. Sent an email.

Mitch: I had nothing in my stash either. I believe this same washer was used up until 62.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

The Following User Says Thank You to Stefano For This Useful Post:
Xplantdad (Yesterday)

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.