Re: 9 Fin Corvette valve covers
[ QUOTE ]
Yo Dog427/435, pm me or call me at (585) 748-8777.
Somehow over the years I have aquired 3 (yeah, go figure, 3) of these valve covers. I haven't looked at them in sometime but I know they are the early ones. I was going to figure out how to make a "spacer" for them so I could use them on later motors, but if you have a need for them, please contact me and lets see if they are correct for your application. Out with the old, in with the other old stuff.
[/ QUOTE ]
ronebee
Just for grins, look inside your 3 covers and see if they were made by "The Hoover Co." here in North Canton.
By Buddy who retired from there as a tool and die maker remembers polishing the molds after they would start to wear.
He showed me a set of 7 finned ones he has with the HOOVER logo on the inside.
Mike
|